TROUBLESHOOTING GUIDE · CONYERS, GA
When a Frigidaire refrigerator stops cooling. The cause is usually one of a handful of common. Well-known issues rather than something exotic. This guide walks through the checks almost every homeowner can safely do. The Frigidaire-specific setting that sometimes gets overlooked. And The signs that point to a part that needs a technician.
✂️ CONYERS & ROCKDALE COUNTY COUPON
Service fee waived with any repair
Mention code CONYERS-FEE-WAIVED when you call, or enter it on the request form. Same-day scheduling available.
Common reasons a Frigidaire refrigerator stops cooling
- Dirty or blocked condenser coils — Coils covered in dust and pet hair cannot shed heat efficiently, so the fridge runs warmer than it should.
- Blocked air vents inside the cabinet — Overpacking the fridge or freezer blocks the vents that circulate cold air between the two compartments.
- A door that is not sealing — A torn, dirty, or warped door gasket lets warm air leak in continuously, so the compressor runs constantly and still does not keep up.
- Demo or showroom mode left on — Some Frigidaire models have a demo or showroom display mode that turns off cooling. Check the owner’s manual for how your model shows and exits this mode.
- A failed evaporator fan, start relay, or compressor — These parts do not respond to cleaning or resets and need a technician to diagnose and replace.
What You Can Check Yourself (Frigidaire Refrigerator Not Cooling)
- Vacuum the condenser coils (usually behind a bottom kick-plate or on the back of the unit) — this is the single most common fix.
- Make sure nothing is blocking the internal air vents, especially in the back of the freezer compartment.
- Check that the door gasket makes full contact all the way around — a dollar bill should grip snugly when the door is closed on it.
- Confirm the temperature control is set correctly (not accidentally turned down or switched to a demo setting) and give it 24 hours to stabilize after any change.
- Make sure the fridge has a few inches of clearance around it for airflow, and is not pushed flush against a wall.
When it is a part, not a setting
If the coils are clean, the door seals properly, and the vents are clear but the fridge is still warm, that usually points to a mechanical or electrical part rather than something you can fix yourself:
- The compressor is not running or not cycling on at all (listen for the usual hum)
- You hear clicking from the compressor area every few minutes but it never starts
- The evaporator fan (inside the freezer) is silent — you should normally hear a faint fan noise
- Frost has built up heavily on the back wall of the freezer, which can point to a defrost system problem
Why this is not just an inconvenience
The FDA recommends keeping refrigerators at or below 40°F and freezers at 0°F to keep food safe. If your fridge has been running warm for more than a couple of hours, it is worth checking food temperatures before deciding what is safe to keep.
Need a technician in Conyers, GA?
Same-day appointments available. Mention code CONYERS-FEE-WAIVED for a waived service fee.
→ Refrigerator Not Cooling? What to Check First
Frequently asked questions
Why is my Frigidaire fridge cold but the freezer is not, or the other way around?
That split usually points to a blocked air vent or a failing evaporator fan rather than the compressor itself, since both compartments share the same cooling source on most models.
How long should I wait after cleaning the coils before calling for service?
Give it about 24 hours. If the temperature has not come back down by then, the coils likely were not the only issue.
Is a warm refrigerator an emergency?
Not usually, but food safety is time-sensitive — the FDA 40°F guideline is a good checkpoint for deciding what to keep versus toss if the fridge has been warm for several hours.
For general refrigerator maintenance tips, see the U.S. Department of Energy’s appliance guide.